Configuring Number Query Service; Alarm Clock Service; Introduction To Alarm Clock Service - H3C XE 200 User Manual

User Manual
H3C XE 200/2000 IP PBX G-Remote

5.25.2 Configuring Number Query Service

Table 5-32 Configure the number query service
Step
1
—
Return to

5.26 Alarm Clock Service

5.26.1 Introduction to Alarm Clock Service

With the alarm clock service enabled, a subscriber can set an alarm clock task so that
the XE IP PBX calls the subscriber at the specified time.
Each subscriber can set one alarm clock task at most.
The alarm clock task falls into two types: one-off alarm and cyclic alarm:
Once: The alarm clock goes off only once. The subscriber needs to specify the
alarm date and time. The date defaults to the current day if not specified. The
specified time must be later than the current system time.
Cycle: This type of alarm clock goes off once every day. When setting the alarm
clock service, the subscriber need to set only the time, at which the alarm clock
goes off every day.
Configuration
task
Select [System View/Location
Server/Gateway/the gateway where the
subscriber to be configured is
located/Subscriber/the subscriber to be
Enable/disable
configured] in the navigation tree, and
the number
Select [Self Number Query] in the
query service
configuration window to enable the
for a
number query service for the subscriber.
subscriber
Clear this check box to disable the
number query service for the subscriber.
Command: srv-switch query-self
(subscriber number view)
Configure
other call Refer to
services
XE IP PBX Configuration
Chapter 5 Call Service Configuration
Description
Call Service Overview.
Overview.
5-41
Remarks
Required
Optional