Table of Contents
Advertisement
Chapter 5 System Setting
Type] of low frequency side.
7. Press
to close the menu.
Setup of type of low frequency
5.14.2
transducer
TD Setup - LF TD Type
Select the type of transducer to be actually
used in low frequency. It has to be adjusted
as it has influence on images.
1. Press
.
2. Select [TD Setting] - [LF TD Type].
3. Press [ ] of
The setup box of [LF TD Type] will be
displayed.
4. When a Broadband transducer is used,
press [▲] and [▼] to select [Broadband
Type]. When a transducer other than that
is used, select [Others]. When a low
frequency transducer is not used, select
[OFF].
5. Press of [ ] of
When [Broadband Type] is selected, the
setup box of Broadband Type will be
displayed.
When [Others] is selected, the setup box
of others will be displayed.
6. Press [▲] or [▼] to select a transducer to
use.
The TD selected as a [Broadband Type]
is reflected to the [Broadband Type] of
high frequency side.
7. Press
to close the menu.
5.14.3 Setup of frequency and beam
angle for HF 1 transducer
TD Setting - HF TD1 Setting
1. Press
.
5-10
.
.
2. Select [TD Setting] - [HF TD1 Setting]
3. Press [ ] of
The setup box of [HF TD1 Setting] will be
displayed.
4. Select [Frequency] for changing of
frequency, and [Beam angle] for changing
of beam angle with [▲] and [▼] keys.
5. Press [ ].
When [Frequency] is selected, the setup
box of frequency will be displayed.
When [Beam Angle] is selected, the
setup box of beam angle will be
displayed.
6. Setup frequency or beam angle with [▲]
and [▼] keys.
When [Broadband Type] is selected in
5.13.1 or 5.13.2, beam angle will be
automatically set at setup of frequency.
7. Press
to close the menu.
Caution: The setup of beam angle
is reflected on the display of
detecting range and will not
change the actual beam angle.
(As for beam angle, refer to
Installation Manual, [Type of
transducer] in Configuration of
Equipment)
JFC-180BB
.
7ZPNA4619A
Advertisement
Table of Contents
