Table of Contents
Advertisement
4.2.2 Uploading to Digital Amplifier System Units one by one
•
Disconnect System Bus wires between DIGITAL AMPLIFIER units
•
Upload to Master unit and choose "No" for "Do you want to send to slave units also?"
•
After the uploading disconnect USB-cable from Master DIGITAL AMPLIFIER and wait until status "DIGI AMP not
Connected" is displayed on configuration program status bar
•
Connect USB-cable to the next DIGITAL AMPLIFIER Unit and wait for "DIGITAL AMPLIFIER connected" status
before start uploading
•
Go through all units of the system
•
Shut down power from all units
•
Reconnect System Bus wires and power up the system
4.2.3 Downloading Configuration from System
All DIGITAL AMPLIFIER units on the system contain the same configuration and the easiest way to download the
configuration is to load it from master unit. Make sure "DIGITAL AMPLIFIER connected" is displayed on status bar before
starting to download. Password will be asked for a first download. (Default passwords is 0000)
Note After downloading save the project on PC. If the project does not exist on computer create a new project
folder with "save file as"-command.
4.3 System Setup using AlphaAnnounce Configuration Software
AlphaAnnounce configuration software is an easy to use tool to create all needed functions for all size of sound and
alarm systems. It is used to define routings of for program sources and announcements, system monitoring and remote
control features from/to external devices and units. To understand the possibilities of the ALPHAANNOUNCE DIGITAL
PA/VA system it is recommended to browse through all configuration windows to get an understanding what can be done
with the software.
36 | AlphaAnnounce Software Configuration
Advertisement
Table of Contents
