Table of Contents
Advertisement
2-4 Introduction to installation
Note: If any of the below operation is incorrect, turn off the power immediately and check the scanner for
any improper connections. Go through all steps again.
2-4-1 Installation - USB
The scanner attaches directly to a USB host, and is powered by it. No additional power supply is
required.
1.
Refer to Figure 2-4, connect the USB interface cable to the bottom of the scanner.
2.
Plug the series A connector in the USB host, or an available port of the terminal.
3.
Windows will automatically detect the USB device.
Figure 2-4 Installation - USB
7
Advertisement
Table of Contents
