3-2 Example: configure scanner
Note: The factory default settings are indicated with asterisks (*) in this manual.
1、Single-scan setting
Scan the appropriate Single-scan setting barcode according to the user's demand.
Example: Set Flow control to be none.
Steps: Scan the following barcode.
2、Multiple-scan setting
The steps of configuration are:
a) Scan the SETUP barcode on the parameter setting part.
b) Enter the option mode by scanning the Parameter name barcode.
c) To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these
alphanumeric entries (see
Value.
d) Scan the END barcode, listed on the bottom of each parameter setting part.
Notes that only one parameter can be setup at each time.
Example: Set Flow control to be none.
Steps: Scan the following barcodes in order.
9 Configuration alphanumeric value
12
barcode)
individually as Para.