Parameter Menus; Introduction - Godex GS200 User Manual

3 Parameter menus

3-1 Introduction

This section describes the programmable parameters, provides barcodes for programming.
The scanner is shipped with the factory default settings as described in this chapter. These
factory-default-settings values are stored in flash memory and are preserved even when the scanner is
powered down. Changes to the factory default values can be stored as custom defaults. These values
are also stored in flash memory and are preserved even when the scanner is powered down.
There are two methods to change the parameter values as described following.
Scan the appropriate barcodes as the example shown in
values replace the existing memory values.
7 Return default parameters & firmware version
Referring to
setting (%%WCDF) barcode to set the new values as custom defaults. The factory default or
custom default parameter values can be recalled by scanning the manufacture default setting
(%%%DEF) barcode, or the Restore customer's default setting (%%RSDF) barcode.
3-2 Example: configure scanner
, scan the Write to customer's default
11
. The new