Flashforge Adventurer 3 Pro 2 User Manual page 41

Calibration:
Extruder Calibration:
Click on [Calibration] to start pre-calibration. The first point is to calibrate the initial distance
between the extruder and the platform [see z-axis deviation value]. Click on the up and
down arrows to adjust the Z-axis deviation value. You can also feel if there is slight
resistance by pulling A4 paper or leveling card between them to decide the appropriate
distance.
Homing
To make the X, Y and Z axes back to the mechanical zero point.
Status Language
Calibration Homing
1/4
The extruder moves to the right;
The extruder moves to the left;
The build plate moves to the front;
Manual:
To manually adjust the
positions of the extruder
and build plate.
Homing, please wait...
Yes
The build plate moves to the back;
The extruder moves upward;
The extruder moves downward;
Move Camera
Filament Check Led
2/4
38
Homing completed
Yes
X: 20.00 Y: 45.00 Z: 36.00
Y
X
Z