Mitsubishi Outlander 2017 Owner's Manual page 350

Programming a new Home-
®
Link
®
To program HomeLink to operate a garage
door, gate, or entry door opener, home or
office lighting, you need to be at the same
location as the device.
®
1. Press the HomeLink button that you
would like to program. The indicator light
(A) will flash orange slowly.
NOTE
 You do not need to continue holding the
®
HomeLink button.
 If the indicator light does not flash, refer to
"Cleaning the programmed information" on
page 5-272.
2. Position the end of your hand-held trans-
mitter (B) 1 to 3 inches (2 to 8 cm) away
from the HomeLink
N00584700020
ing the indicator light in view.
NOTE
 Some hand-held transmitters may actually
train better from a distance of 6 to 12 inches
(15 to 20 cm). Keep this in mind if you have
difficulty with the programming process.
3. Press and hold the hand-held transmitter
button while watching the indicator light
(A). Continue pressing the button until the
indicator light (A) changes from slowly
flashing orange to either rapidly flashing
green (rolling code) or continuously lit
green (fixed code). Now you may release
the hand-held transmitter button.
HomeLink® Wireless Control System (if so equipped)
NOTE
 Some devices may require you to replace this
®
button while keep-
"Programming a new HomeLink
with procedures noted in the "Gate operator /
Canadian programming" section. If the indi-
cator light does not change to rapidly flash-
ing green or continuously lit green after
performing these steps, contact HomeLink
at www.homelink.com
4. Press the HomeLink
programmed and observe the indicator
light.
• If the indicator light continuously illumi-
nates green, programming is complete
and your device should operate when the
HomeLink
released.
• If the indicator light rapidly flashes
green, firmly press, hold for 2 seconds
and release the programmed HomeLink
button. Repeat the "press/hold/release"
sequence a second time, and, depending
on the brand of the garage door opener
(or other rolling code equipped device),
repeat this sequence a third time to com-
plete the programming process. At this
point if your device operates, program-
ming is complete.
®
" step 3
®
®
button that was just
®
button is pressed and
®
Features and controls 5-269
5