Mitsubishi Outlander 2017 Owner's Manual page 151

Automatic transaxle (if so equipped)
Selector lever position display
When the operation mode is put in ON, the
selector lever position is shown on the multi-
information display.
5
Type 1 Type 2
Warning display
[For vehicles equipped mono-color liquid
crystal display meter]
5-70 Features and controls
When the selector lever position indicator
blinks while you are driving, there could be a
N00513901441
malfunction in the automatic transmission
system or A/T fluid temperature becomes
abnormally high.
NOTE
 The "A" indicator on the selector lever posi-
tion display will only blink if there is a prob-
lem with the A/T position switch.
N00514001292
It is not seen during normal driving.
CAUTION
 If a malfunction occurs in the A/T while
driving, the indicator will blink.
In this case, immediately park your vehicle
in a safe place and follow these procedures:
[If the indicator blinks rapidly (once per sec-
ond), the A/T fluid is overheating.]
Park your vehicle in a safe place but do not
turn off the engine. Move the selector lever
to the "P" (PARK) position and open the
bonnet. Keep the engine, idling.
After a while, move the selector lever into
any position other than "P" (PARK) position
and confirm that the indicator stops blinking.
It is safe to continue driving if the indicator
no longer blinks.
If the indicator continues blinking or blinks
intermittently, have your vehicle inspected
by an authorized Mitsubishi Motors dealer or
a repair facility of your choice.
[If the indicator blinks slowly (once per 2
seconds), the A/T safety device may be oper-
ating due to a malfunction.]
Have the vehicle inspected by an authorized
Mitsubishi Motors dealer or a repair facility
of your choice immediately.
[For vehicles equipped with color liquid
crystal display meter]
or