Mitsubishi Outlander 2017 Owner's Manual page 122

CAUTION
 Do not apply excessive force to the power
liftgate when opening or closing it. Doing so
could damage to the power liftgate.
NOTE
 Do not start the engine while the power lift-
gate is operating. The sudden operation pre-
vention mechanism could operate, making
the power liftgate stop intermittently while it
moves.
 The power liftgate cannot be opened when
the battery is discharged or disconnected.
The liftgate must be then opened using the
inside liftgate release.
Refer to "Inside liftgate release" on page
5-46.
 If the keyless entry system or close switch is
operated when the power liftgate main
switch is off, the warning buzzer sounds 4
times to notify the driver that the power lift-
gate cannot be operated.
 The power liftgate does not operate normally
under the following conditions:
• When parked on an incline
• In strong winds
• When the power liftgate is covered with
snow
 Repeated continuous opening and closing
operation of the power liftgate will activate a
built-in protection circuit and switch the
power liftgate to manual operation.
NOTE
 If one of the power liftgate switches is oper-
ated while the power liftgate is operating, the
power liftgate will reverse and return to the
full open or close position.
 If the selector lever is moved from "P"
(PARK) position to another position while
the power liftgate is operating or completely
open, a warning buzzer will sound for
approximately 10 seconds to notify the
driver that the power liftgate is open.
 If the battery or fuse is replaced while the
power liftgate is open, it cannot be closed
automatically.
In this case close the power liftgate manu-
ally.
Operating conditions
The power liftgate can be opened automati-
cally when all of the following conditions are
met.
<Using the F.A.S.T.-key>
 The operation mode is in OFF.
 The power liftgate is completely closed.
 The power liftgate is unlocked.
<Using the driver's side power liftgate
switch>
 The operation mode is in ON with the
selector lever in the "P" (PARK) position.
Power liftgate (if so equipped)
 The power liftgate is completely closed.
 The power liftgate is unlocked.
<Using the open switch on the power lift-
gate>
 The power liftgate is unlocked.
 The F.A.S.T.-key is within the operating
range (2.3 feet (70 cm) from the power
liftgate open switch) and the power lift-
gate is locked.
The power liftgate can be closed automati-
cally when all of the following conditions are
met.
<Using the F.A.S.T.-key>
 The operation mode is in OFF.
 The power liftgate is completely open.
N00576100038
 Nothing is touching the auto reverse sen-
sors (A) on the power liftgate.
Features and controls
5
5-41