Mitsubishi Outlander 2017 Owner's Manual page 222

WARNING
• When passing through a place where the
brightness suddenly changes, such as at
the entrance to or exit of a tunnel.
• When the headlights of an oncoming
vehicle are very bright.
• When the rear of your vehicle is weighed
down with the weight of passengers and
luggage.
• When the headlights of your vehicle are
not clean or are not properly aimed.
• When the front windshield is not clean.
• When the front windshield wipers do not
clean the windshield properly.
CAUTION
 To maintain proper function of the LDW:
• Always keep the windshield and the head-
lights clean.
• Do not put anything, such as a sticker, on
the front windshield in front of the sensor.
• Avoid applying a shock or load to the sen-
sor.
• Do not attempt to detach or disassemble the
sensor.
• Use only Mitsubishi Motors Genuine parts
when replacing the windshield wipers.
NOTE
 When driving conditions are not suitable to
use the LDW, turn off the LDW.
Lane Departure Warning System (LDW) (if so equipped)
System problem warning
If a problem occurs with the system, a visual
warning specific to the type of the problem is
given together with an audible alarm.
Sensor is too hot or cold
The alarm shown below is displayed if the
system becomes temporarily unavailable due
to the high or low temperature of the sensor.
After temperature of the sensor has been in
range, the system will automatically return to
operation.
If the alarm continues showing, there is a pos-
sibility that the LDW has a malfunction. Con-
tact an authorized Mitsubishi Motors dealer
for inspection of the system.
Windshield is dirty
N00578100045
The alarm shown below is displayed if the
system becomes temporarily unavailable due
to the dirty windshield of the sensor portion.
After having cleaned the windshield, the sys-
tem will automatically return to operation.
If the alarm continues showing, there is a pos-
sibility that the LDW has a malfunction. Con-
tact an authorized Mitsubishi Motors dealer
for inspection of the sensor.
Features and controls
5
5-141