Installation; Clearances; Location - Vulcan-Hart QUICKFRY VHG-A Series Installation & Operation Manual

VHG SERIES GAS FRYERS
• Suction Tube
• Screen Assembly
• High temperature discard hose
• Crumb Basket
• Manual, Quick Start Guide(s), and Warranty-Keep in safe place for reference
Do not use the door or its handle to lift the fryer.
Before installing the fryer, verify that the type of gas (natural or propane) agrees with the
specifications on the fryer data plate, which is located on the inside of the door panel.
Make sure the fryer is configured for the proper elevation.
Record your fryer model, device, and serial numbers for future reference in the space
provided below. This information can be found on the fryer data plate.
Fryer Model No: ___________________________
Device: ___________________________________
Serial No: ________________________________

Clearances


Minimum clearance from combustible construction:
6" (15 cm) from the sides of the fryer
6" (15 cm) from the back of the fryer
The fryer may be installed on combustible floors

Minimum clearance from noncombustible construction:
0" from the sides of the fryer
0" from the back of the fryer

Between the fryer and any open-top flame units:
16" (41 cm)

Allow space for servicing and operation.
Some service procedures will require removal of side panels or access to rear of the
unit.

Location


Install fryer in an area with sufficient air supply for gas combustion.

Do not obstruct the flow of combustion and ventilation air.

Provide adequate clearance for air openings into the combustion chamber.
VULCAN

INSTALLATION

-5-
F-47679 Rev. A (3-20)