Extended Shutdown; General; Assembly - Vulcan-Hart QUICKFRY VHG-A Series Installation & Operation Manual

VHG SERIES GAS FRYERS

Use a damp cloth with warm water and a mild soap or detergent.
Do not use chlorine or sulfate/sulfide cleaners.

Rinse thoroughly, and then dry with a soft dry cloth.

Keep the fryer exterior clean and free of accumulated grease to prevent
stubborn stains from forming. If regular cleaning is neglected, grease will be burned
on and discolorations may form.

Remove discolorations by washing with any detergent or soap and water.

Use a self-soaping, non-metallic scouring pad for particularly stubborn
discolorations.

Always rub with the grain of the stainless steel.

Do not use a metallic scoring pad or harsh cleaners.
1. Thoroughly drain the fryer. Refer to DRAINING THE FRYER.
2. Clean the fryer according to CLEANING.
3. Push Power switch to the off position
4. Turn off the main gas shutoff valve.

General

The KleenScreen PLUS® filtration system filters the oil as it is pumped back into its' respective
tank(s). Only one tank can be drained and filtered at a time. Under no circumstances should
more than one tank be drained at the same time.

Assembly

•
After unpacking, wash the filter pan, crumb basket, suction tube and filter screen assembly.
Make sure you remove the insert located inside the filter screen. Use dishwashing detergent
and warm water, (parts are dishwasher safe). Rinse the filter pan, crumb basket and filter
screen components completely and wipe all parts dry with a clean cloth.
•
Pull out the filter pan all the way and remove to wash.
•
The filter pan slides can be removed for washing by pushing the slides back into the fryer.
Then rotate the bottom of the slide toward the center of the fryer and lift out. Reverse the
procedure to install.
VULCAN

EXTENDED SHUTDOWN

KLEENSCREEN PLUS® FILTRATION SYSTEM
-16-
F-47679 Rev. A (3-20)