Flush/Rinse And Discard Oil - Vulcan-Hart QUICKFRY VHG-A Series Installation & Operation Manual

VHG SERIES GAS FRYERS
4.The display will indicate drn. When
the fry tank is empty, turn on the filter
pump by pressing the filter icon
button for 3-4 seconds. Allow the pump
to filter the oil for a couple of minutes
before closing the drain valve.

FLUSH/RINSE AND DISCARD OIL

1.Follow filtering instructions 1-3, however do not put oil treatment media into the fryer. Drain the fryer oil into
the filter pan.
2.Attach the quick disconnect hose to the discard male quick disconnect fitting.
3.To discard the oil, place the nozzle end of the discard hose into a container that is large enough to retain the
discarded shortening. Press the filter switch behind the door to the "USE HOSE TO DISCARD ONLY" position. This
will allow all of the oil to be pumped through the hose only.
4.For flushing/rinsing the tank with filtered oil to remove the particulates that have accumulated, press the filter
switch behind the door to the "USE HOSE TO RINSE AND FILL" position. This will allow the oil to pass through the
hose and come in from behind the tank at the same time.
the filter pump is engaged.
5.With the power switch still ON; press and hold the filter button for at least 3-4 seconds and the Motor/Pump will
begin to operate.
6.Once the oil has been discarded completely and the filter pan is empty, press the filter button to turn off the
Motor/ Pump.
cause burns.
7.Disconnect the discard hose. Be careful to let the hose drain before putting away. Close the drain valve and fill the
fry tank with new oil.
If discard vessel is not large enough to hold the entire shortening amount, stop the flow by pushing the filter
button to to turn the motor/pump off. Empty the container and resume discard operation by pressing the filter holding for 3-4
seconds.
If power is mistakenly turned off during the filtering operation, the corrective action is as follows.
1. Close the drain valve
2. Turn the power switch on
3. Immediately open drain valve
4. Continue filtering operation
VULCAN
5. Close the drain valve. The display
will begin to scroll; FILL VAT-PRESS
FILTER. The display will alternate from
FILLING to PRESS FILTER. Fill to
between the MIN and MAX lines on
the back of the fryer tank. Oil will
expand as it is heated. Do not fill the
fryer tank past the MAX line.
Oil will immediately exit out of the nozzle end of the hose any time the hose in plugged in and
The hose connection will be hot due to the temperature of the oil that was discarded and can
-22-
6.Press the filter icon button again to
stop the filter pump. The display will
begin to scroll; VAT FULL?-PRESS
START. Press the START(V) button.
The fryer will then begin heating the
oil to the desired temperature.
F-47679 Rev. A (3-20)