Removing Excess Debris From The Filter; Filtering Tip; Boil Out Procedure - Vulcan-Hart QUICKFRY VHG-A Series Installation & Operation Manual

Table of Contents

Advertisement

Available languages

Available languages

VHG SERIES GAS FRYERS

FILTERING TIP:

Open the filtering drawer approximately 1" to allow any oil in the return line to run back into the filter pan. This will take about
30 seconds to complete. Then open the drawer completely to clean filter components.
REMOVING EXCESS DEBRIS FROM THE SCREEN FILTER:
Hot oil and hot parts can cause burns.
Never run water or boil out solution through filter and motor / pump. Doing so will void
your fryer warranty.
Filter ONLY one fry tank at a time to avoid overflow and spillage.
Open the filtering drawer approximately 1" to allow any oil in the return line to run back into the filter
pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter
components.
1. Pull the filter drawer out.
2. Remove the filter screen assembly. Scrape debris from the filter screen. Then remove the
insert by unlatching the latch. Clean all parts thoroughly as mentioned in the assembly
section on page 16.
3. Scrape debris from the bottom of the filter pan and discard in the trash. Clean all parts
thoroughly as mentioned in the Assembly section on page 16.
4. Reassemble all filter components after being dried thoroughly as in the assembly section on
page 16.

BOIL OUT PROCEDURE:

Hot oil and hot parts can cause burns.
Never run water or boil out solution through filter and motor / pump. Doing so will void
your fryer warranty.
1. Discard oil as described under FLUSH/RINSE AND DISCARD OIL section
2. Close the drain valve and fill tank with water. Use a boil out solid degreaser which can be
ordered from your local dealer. Follow the instructions on the side of the package.
Do not use chlorine or sulfate /sulfide cleaners.
3. Solution level must be between the MIN and MAX levels on the fryer tank.
4. Turn the power switch to the on position. With solid state knob controls (A), set the
temperature setpoint to 195°F. Press the start button. Water boils at 212°F.
VULCAN
FILTERING TIP:
-23-
F-47679 Rev. A (3-20)

Advertisement

Table of Contents
loading

Table of Contents