Table of Contents
Advertisement
ESAB CuTmASTEr 100
4T.04 Hand Torch Operation
Standoff Cutting With Hand Torch
NOTE!
For best performance and parts life, always use the
correct parts for the type of operation.
1. The torch can be comfortably held in one hand
or steadied with two hands. Position the hand
to press the Trigger on the torch handle. With
the hand torch, the hand may be positioned
close to the torch head for maximum control or
near the back end for maximum heat protec-
tion. Choose the holding technique that feels
most comfortable and allows good control and
movement.
NOTE!
The tip should never come in contact with the
workpiece except during drag cutting operations.
2. Depending on the cutting operation, do one of
the following:
a. For edge starts, hold the torch perpendicu-
lar to the workpiece with the front of the tip
on the edge of the workpiece at the point
where the cut is to start.
b. For standoff cutting, hold the torch 1/8 - 3/8
in (3-9 mm) from the workpiece as shown
below.
Torch
Shield Cup
A-00024_AB
Standoff Distance
3. Hold the torch away from your body.
4. Slide the trigger release toward the back of the
torch handle while simultaneously squeezing
the trigger. The pilot arc will start.
4T-4
All manuals and user guides at all-guides.com
Standoff Distance
1/8" - 3/8" (3 - 9mm)
OPERATION
Trigger Release
5. Bring the torch within transfer distance to the
work. The main arc will transfer to the work,
and the pilot arc will shut off.
NOTE!
The gas preflow and postflow are a characteristic of
the power supply and not a function of the torch.
Trigger
1
Trigger Release
3
4
6. Cut as usual. Simply release the trigger as-
sembly to stop cutting.
7. Follow normal recommended cutting practices
as provided in the power supply operator's
manual.
NOTE!
When the shield cup is properly installed, there
is a slight gap between the shield cup and the
torch handle. Gas vents through this gap as part
of normal operation. Do not attempt to force the
shield cup to close this gap. Forcing the shield cup
against the torch head or torch handle can damage
components.
8. For a consistent standoff height from the
workpiece, install the standoff guide by sliding
it onto the torch shield cup. Install the guide
with the legs at the sides of the shield cup
body to maintain good visibility of the cutting
arc. During operation, position the legs of the
standoff guide against the workpiece.
Trigger
A-02986
2
Art # A-11504
Manual 0-5404
Advertisement
Table of Contents
