Signode VT-10 Operation, Parts And Safety Manual page 13

3. Recheck the strap alignment at
the rear of the tool and realign if
necessary. Release the tension
motor.
Press down the Green Tension
Control Lever to begin
tensioning the strap.
When the tension motor stalls,
indicating completion of
tension, release the control
lever. The strap will remain
tensioned around the package.
NOTE: If the strap alignment is unsatisfactory or the tool needs to be removed before sealing.
First, move the Red tension release latch to the left to disengage the tension motor. Squeeze
the tension motor and stationary handle together to open the strap path.
4. Press the Blue Sealer Control
lever to begin the sealing cycle.
It is not necessary to continue
holding the lever down once the
weld cycle has started.
13