Bosch SCT 815 S5 Original Operating Instructions page 21

1
2
(1) Mount for laser range finder
(2) Prismatic reflector
4. Make sure the edges of the prismatic reflector
are aligned with the centers of the notches
mount for the laser range finder.
1
2
(1) Edges of prismatic reflector
(2) Notches in mount for laser range finder
Should the edges of the prismatic reflector be
misaligned with the centers of the notches, the
mount for the laser ranger finder will be inaccur‐
ately positioned. As a consequence,
SCT 815 S5/S6 cannot be correctly aligned.
5. Insert the laser range finder
shelf (2).
1
2
3
(1) Laser range finder
(2) Horizontal shelf
(3) Positioning foot
6. Use the positioning foot (3) to level SCT 815 S5/S6
based on the inclination angle indicator
range finder.
Robert Bosch GmbH
1
(1)
(2)
in the
1
2
4712008-10_shd
(1)
into the horizontal
of the
laser
 WARNING – severe eye damage from laser beam.
7. Never look directly into the laser source.
8. To test function, hold an object in front of the exit
point of the laser range finder.
9. Switch on the laser range finder.
 CAUTION – risk of crushing when adjusting the
height of the prismatic reflector.
10. Do not place fingers between the tool holder and
the guide tubes.
11. Loosen the knurled screw
til the height of the prismatic reflector can be adjus‐
ted.
3
2
1
(1) Knurled screw
(2) Laser beam
(3) Laser point on manufacturer's badge
12. Adjust the height of the tool holder in such a way
that the red laser point is directed at the manufac‐
turer's badge or front radar sensor, depending on
the specification in the brief instructions.
13. Use the knurled screw to secure the tool holder.
---
4.6 Setting the offset (up to 25 cm) from
the vehicle's longitudinal center plane
---
 SCT 815 S5/S6 must be aligned with the vehicle's
longitudinal center plane.
---
The offset of the prismatic reflector from the vehicle's
longitudinal center plane is specified in the corre‐
sponding brief instructions. The offset specific to the
vehicle is found in the column with the following picto‐
gram.
---
1. Use the corresponding brief instructions.
2. Look up the offset of SCT 815 S5/S6 for the relevant
vehicle.
3. Use the ruler on the tool holder
of the prismatic reflector.
SCT 815 S5/S6 | 21 | en
(1)
on the tool holder un‐
(1)
to set the offset
1 689 989 475 | 2023-06-28