Bosch SCT 815 S5 Original Operating Instructions page 18

en | 18 | SCT 815 S5/S6
1
2
(1) Mount for laser range finder
(2) Prismatic reflector
5. Make sure the edges of the prismatic reflector
are aligned with the centers of the notches
mount for the laser range finder.
1
2
(1) Edges of prismatic reflector
(2) Notches in mount for laser range finder
Should the edges of the prismatic reflector be
misaligned with the centers of the notches, the
mount for the laser ranger finder will be inaccur‐
ately positioned. As a consequence,
SCT 815 S5/S6 cannot be correctly aligned.
6. Insert the laser range finder
shelf (2).
1
2
3
(1) Laser range finder
(2) Horizontal shelf
(3) Positioning foot
7. Use the positioning foot
based on the inclination angle indicator of the laser
range finder.
1 689 989 475 | 2023-06-28
1
(1)
(2)
in the
1
2
4712008-10_shd
(1)
into the horizontal
(3)
to level SCT 815 S5/S6
 WARNING – severe eye damage from laser beam.
8. Never look directly into the laser source.
9. To test function, hold an object in front of the exit
point of the laser range finder.
10. Switch on the laser range finder.
11. Adjust the height of the prismatic reflector in such a
way that the laser point marks the center of the
bumper.
 The laser range finder indicates the current dis‐
tance between SCT 815 S5/S6 and the bumper.
The laser range finder measures distance contin‐
uously. If the position of SCT 815 S5/S6 changes,
the new distance from the bumper will be shown
on the display of the laser range finder.
12. Make sure the back of the laser range finder touches
the rear stop of the horizontal shelf.
2
1
3
(1) Laser range finder
(2) Rear stop of horizontal shelf
(3) Mount for laser range finder
If the back of the laser range finder does not
touch the rear stop of the horizontal shelf, there
will be observational errors.
13. Use the laser range finder to position
SCT 815 S5/S6 at the precise specified distance
from the front of the vehicle.
 The position of SCT 815 S5/S6 is correct when
the laser range finder reading matches the speci‐
fication from the brief instructions.
---
4.4 Aligning SCT 815 S5/S6 with the vehi‐
cle's longitudinal center plane
(1)
1. Attach the line laser
ser (4), and use the retaining cable to secure it.
2. Use the positioning feet
in accordance with the spirit level on the mount for
the line laser (2).
to the mount for the line la‐
(3)
to level SCT 815 S5/S6
Robert Bosch GmbH