Table of Contents
Advertisement
4.
Attach the other end of the Serial ATA cable to the
Serial ATA connector on the SATA II PCIe.
Figure 3. Connecting the Serial ATA data cable(s)
5.
Follow the same instructions when connecting a
second hard drive. Device connection is now
complete.
6.
Replace the computer cover and reconnect the power
cord.
Driver Installation
This section provides information on how to install the
SATA II PCIe drivers:
Windows 2000
New Windows 2000 Installation
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the contents of the Floppy folder, found on the
driver CD, onto a blank floppy disk then follow the
directions below.
1.
Install the board and follow Microsoft procedures to
install Windows 2000 accordingly.
2.
Restart your system when prompted during
Windows' installation.
4
Advertisement
Table of Contents
