Table of Contents
Advertisement
3.
At the Windows 2000 Setup screen, press F6 to
install the driver.
4.
Insert the driver diskette. Press S, then press Enter.
5.
Select Silicon Image SiI 3132... Controller for
Windows 2000 and press Enter.
6.
Press Enter to continue and follow on-screen
instructions to complete the installation.
Existing Windows 2000 Installation
1.
Install the board and boot up Windows 2000.
2.
At the Found New Hardware Wizard, click Next.
3.
Select Search for a suitable driver for my device
(recommended) and click Next.
4.
Insert the driver CD, check CD-ROM drives, uncheck
the other boxes, and click Next. Click Next again to
continue.
5.
Click Finish
6.
Restart Windows to complete the driver installation.
Windows XP/Server 2003
New Windows XP/Server 2003 Installation
A new installation of Windows XP/Server 2003 requires
a floppy disk for the driver installation. To make this
floppy disk, copy the contents of the Floppy folder,
found on the driver CD, onto a blank floppy disk then
follow the directions below.
1.
Install the board and follow Microsoft procedures to
install Windows accordingly.
2.
Restart your system when prompted by Windows'
installation.
3.
At the Windows Setup screen, press F6 to install the
driver.
5
Advertisement
Table of Contents
