Table of Contents
Advertisement
32-bit Windows Vista™
For New Windows 32-bit Vista Installation
1.
Install the board and follow Microsoft procedures
to install Windows accordingly.
2.
Restart your system when prompted during
Windows' installation.
3.
At Where do you want to install Windows?, click
Load Driver.
4.
Insert driver CD, then click Browse
5.
Double click CD Drive (D:), (change D: to match
CD-ROM)
6.
Highlight Floppy folder, then click OK
7.
Select Silicon Image SiI 3132... Controller
(D:\Floppy\SI3132.inf), then click Next
8.
Follow on-screen instructions to complete Windows
Vista installation.
For Existing 32-bit and 64-bit Vista Installation
1.
Install the board and boot up Windows.
2.
At the Found New Hardware Wizard, insert the
driver CD, select Locate and install driver software
(Recommended), then click Continue.
3.
Click Next, then Close
4.
Remove the driver CD and restart Windows to
complete the installation.
64-bit Windows Vista
For New Windows 64-bit Vista Installation
1.
Install the board and follow Microsoft procedures
to install Windows accordingly.
2.
Restart your system when prompted during
Windows' installation.
8
Advertisement
Table of Contents
