Table of Contents
Advertisement
4.
Insert the driver diskette. Press S then press Enter.
5.
Select Silicon Image Sil 3132... Controller for
Windows XP and Server 2003 and press Enter.
6.
Press Enter to continue and follow on-screen
instructions to complete Windows XP/2003
installation.
Existing Windows XP/Server 2003 Installation
1.
Install the board and boot up Windows
2.
At the Found New Hardware Wizard.
XP (w/SP1 or earlier)/Server 2003: continue to step #3
XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): select
No, not at this time, then click Next.
3.
At the Found New Hardware Wizard, select Install
the software automatically (Recommended), then
click Next.
4.
Click Finish
5.
Restart Windows to complete the driver installation.
64-bit Windows XP/Server 2003
For New Windows 64-bit XP/Server 2003 Installation
A new installation of Windows XP/Server 2003 requires
a floppy disk for the driver installation. To make this
floppy disk, copy the contents of the 64bit folder, found
on the driver CD, onto a blank floppy disk then follow the
directions below.
1.
Install the board and follow Microsoft procedures
to install Windows accordingly.
2.
Restart your system when prompted during
Windows' installation.
3.
At the Windows Setup screen, press F6 to install the
driver.
6
Advertisement
Table of Contents
