Table of Contents
Advertisement
2.
Unplug the power cord from the back of the
computer. Remove your computer cover.
3.
Remove the slot bracket from an available PCIe slot.
4.
To install the card, carefully align the card's bus
connector with the selected PCIe slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
5.
Replace the slot bracket holding screw to secure the
card.
Device Connection
The SATA II PCIe is a dual channel Serial ATA II controller
that supports up to two Serial ATA hard disk drives. If
you plan to use the second channel, you will need to
purchase another Serial ATA cable.
1.
Install hard disk drive(s) in chassis.
2.
Connect the Serial ATA hard disk drive to the system
power supply using the Serial ATA power cable.
3.
Connect one end of the Serial ATA cable to the hard
disk drive.
Note: For hard drives with both SATA power
connector and legacy 5-pin connector, use either
the SATA power connector or the legacy 5-pin
power connector. Using both power connectors
may damage the hard drive.
Figure 2. Hard disk drive connections
Serial ATA cable
Power cable adapter
3
Advertisement
Table of Contents
