Table of Contents
Advertisement
For An Existing Installation
1.
Setup the RAID array prior to driver installation and
boot up to Windows.
2.
At Found New Hardware Wizard, click Next.
3.
Select Search for a suitable driver for my device
(recommended), then click Next.
4.
Insert the driver CD, check CD-ROM drives, uncheck
the other boxes, click Next, then click Next again.
5.
If the Digital Signature Not Found message appears,
click Yes. Our driver has been thoroughly tested for
stability and compatibility.
6.
Click Next, then Finish.
7.
Repeat steps 2-6.
8.
Click Yes to restart to complete the installation.
When Windows resumes, go to Initio SATA RAID
Manager GUI on page 11 and install the RAID utility.
Windows XP/Server 2003
For A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the Floppy folder, found on the driver CD, onto a blank
floppy disk then follow the directions below.
1.
Setup the RAID array prior to Windows installation.
2.
Follow Microsoft's Windows installation procedure.
3.
Restart the computer when prompted by Windows'
installation.
4.
At the Windows Setup screen, press F6 to install the
RAID driver.
5.
When prompted, press S to specify the location of
the driver.
9
Advertisement
Table of Contents
