Table of Contents
Advertisement
1.
Turn OFF the power to your computer and any
other connected peripheral devices.
2.
Unplug the power cord from the back of the
computer.
3.
Remove your computer's cover.
4.
Remove the slot bracket from an available PCI slot.
5.
To install the card, carefully align the card's bus
connector with the selected PCI slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
6.
Replace the slot bracket's holding screw to secure
the card.
7.
Replace the computer cover and reconnect the power
cord.
Device Connection
The SATA II-150 PCI RAID is a two channel Serial ATA
controller that supports two Serial ATA hard disk drives.
It is recommended to use identical hard drives for all
RAID configurations, however, it's possible to combine
hard drives of different sizes and makes.
RAID Arrays
RAID Arrays are setup in the SATA II-150 PCI RAID
BIOS.
RAID 0 (Striping)
This RAID array to be used on New/Blank hard drives.
Striping will destroy existing data on the hard drives.
1.
As the BIOS boots press Ctrl+R when prompted to
enter the RAID BIOS.
2.
At the next screen select RAID , then press Enter.
3
Advertisement
Table of Contents
