Table of Contents
Advertisement
For Existing Hard Drives with Data
1.
During boot press Ctrl+R to enter the RAID BIOS.
2.
Select Disk, press Enter.
3.
Select Reserved for RAID, then press Enter.
4.
Select the single hard drive then press Enter.
5.
When asked, All data in selected drive will lost!
Continue (Yes/No)?, select Yes, then press Enter.
6.
Select RAID, then select Rebuild.
7.
Press Enter. The mirror will begin rebuilding. Do
not interfere with the process.
8.
When rebuilding is finished, select Exit, then press
Enter.
9.
When asked Are You Sure to Exit(Yes/No)?, select
Yes, then press Enter to exit and reboot.
JBOD
This RAID array to be used on New/Blank hard drives.
JBOD will destroy existing data on the hard drive.
1.
As the BIOS boots press Ctrl+R when prompted to
enter the RAID BIOS.
2.
At the next screen select RAID, then press Enter.
3.
Select Create, then press Enter.
4.
Select JBOD, then press spacebar.
5.
Create name, press Enter.
6.
Select Exit, then press Enter.
7.
When asked Are You Sure to Exit(Yes/No)?, select
Yes, then press Enter to exit and reboot.
8.
Continue with Fdisk and Format steps as if you
were installing a conventional hard drive.
5
Advertisement
Table of Contents
