Table of Contents
Advertisement
5.
Click Rebuild Array, then click OK.
6.
The mirror will rebuild. Rebuild time is dependent
on the size of the mirror set.
Deleting RAID Arrays
1.
As the BIOS boots press Ctrl+R when prompted to
enter the RAID BIOS.
2.
Select RAID, then press Enter.
3.
Select the Delete, then press Enter.
4.
Select Exit, then press Enter.
5.
When asked Are You Sure to Exit(Yes/No)?, select
Yes, then press Enter to exit and reboot.
Low Level Format
Low Level Format is built into the RAID BIOS to make it
more convenient to erase the entire contents of a hard
disk drive, including data, drive and partition
information. The Low Level Format utility works on
single hard drives only, before the RAID set is configured.
BIOS Configuration
SATA II-150 PCI RAID BIOS will appear everytime your
system starts up. If the BIOS doesn't show, please try
your controller in another PCI slot. During this (Post)
process, the BIOS will show up and indicate the devices
attached to it.
7
Advertisement
Table of Contents
