Table of Contents
Advertisement
EV40 Manual
CHARGEGUARD ENABLED EV
INSTRUCTIONS
NOTE: The key cannot be removed in the vertical position. See step 4 for key removal
instructions.
4. To restrict access:
a) Turn the key counterclockwise 90° as shown in ChargeGuardTM Addendum Figure 2.
b) Remove the key.
c) If a vehicle is connected and charging, that vehicle will continue to charge as long it
remains connected to the EVSE.
d) Once the vehicle is disconnected from the EVSE, the EVSE will require the key to
activate another charging session.
REPLACEMENT KEYS
If you need replacement keys, please contact the Sun Country Highway office at (866)
467-6920. Please have the serial number of your EVSE available for reference.
Please refer to these instructions to operate the
ChargeGuard enabled EV
EVSE:
1. Connect the HCS EVSE to the vehicle with the
SAE-J1772TM connector.
2. To enable charging:
a) Insert the key into the switch located on the right
side of the HCS EVSE. b) Turn the key 90°
clockwise to the vertical position as shown in the
ChargeGuardTM Addendum Figure 1.
c) The "CHARGING" LED light will illuminate
green on the front panel, indicating the vehicle is
now being charged.
3. To allow charging of Multiple Vehicles:
a) Leave the key in the present vertical position. This
allows disconnection of the EVSE from one vehicle
and reconnection
to the same or another vehicle without moving the
key.
b) The EVSE will be enabled and power will be
available to vehicles as long as the key remains in
the vertical position.
Page ! 2 2
Advertisement
Table of Contents
