Table of Contents
Advertisement
ChargeGuard Enabled HCS
ChargeGuard is a built-in key based access control option. Refer to
these instructions to operate a ChargeGuard enabled HCS EVSE.
1. Connect the HCS EVSE to the vehicle with the
SAE J1772 connector.
2. To enable charging:
a) Insert the key into the switch located on the right side
of the HCS EVSE.
b) Turn the key 90° clockwise to the vertical position as
shown in the Figure 1.
c) The "CHARGING" LED light will illuminate green on
the front panel, indicating the vehicle is now being
charged.
3. To allow charging of Multiple Vehicles:
a) Leave the key in the present vertical position.
This allows disconnection of the EVSE from one
vehicle and reconnection to the same or another vehicle
without moving the key.
b) The EVSE will be enabled and power will be available
to vehicles as long as the key remains in the vertical
position.
Figure 1: ChargeGuard ON or Enabled Position: Charging is
enabled
HCS Optional Features User Manual
9
Advertisement
Table of Contents
