ClipperCreek EV Series User Manual page 16

Table of Contents

EV40 Manual

FOR SOLID-WALL CONSTRUCTION

To secure the unit in concrete, pre-drill appropriately sized holes and use multi-set

or wedge anchor hardware at both mounting points.

To secure the unit in brick or stone, pre-drill appropriately sized holes and use

sleeve anchors at both mounting points.

The included plastic angle washers can be oriented to allow bolts to be fastened

either at an angle or perpendicular to the mounting surface. Note there are two

different sets of plastic angle washers included. Select those washers that best

accommodate the mounting hardware "angle of attack" and orient them accordingly.

Note that if the head of the mounting hardware is smaller than the 3/8" plastic

angle washer aperture, an additional flat washer will need to be placed between the

plastic angle washer and the mounting hardware.

Machine screw size ¼-20 hardware is recommended for mounting the EV.Screw

shafts of at least 2" are recommended. The EV plastic angle washer hole size is

3/8" in diameter, so ensure that the screw heads are of a larger diameter. Place

appropriately sized washers between the screw heads and the EV enclosure

mounting flanges.

Figure 6. Mounting the EV to a solid wall

Page ! 1 6

Table of Contents

Ev40