Connection - Picture Signal Cable - r.LiNK 27-590 Manual

Note: Check the LEDs on CAN-box after reconnecting the battery, two must be on.
Not all vehicles are kompatible. If the CAN-box does not deliver ACC to pin2 of the video-
interface or blocks the thevehicle's CAN, it is possible to install the video interface without
the CAN-box (analog). For analogue connection see 6pin assignment above.
2.4. Connection – picture signal cable
Remove the female Mini USB connector from the rearside of the blackbox and
connect it to the male black Mini USB connector of the picture signal cable.
Connect the female black colored Mini USB connector of the picture signal cable to
the previously become free male Mini USB connector at the rearside of the blackbox.
Connect the female waterblue colored HSD+2 connector to the HSD+2 connector of
the video interface.