Table of Contents
Advertisement
2.7. Picture settings and guide lines
The picture settings are adjusted by the 3 buttons on the video-interface. Press the MENU
button to open the OSD settings menu or to switch to the next menu item. Press UP and
DOWN changes the selected value. The buttons are embedded in the housing to avoid
accidental changes during or after the installation. Picture settings have to be done
separately for AV1, AV2 and CAMERA-IN while the corresponding input is selected and
visible on the monitor.
Note: The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Contrast
Brightness
Saturation
Position H (horizontal)
Position V (vertical)
IR-AV1/2 (no function)
Guide L/R (no function)
UI-CNTRL (ON/OFF) guide lines
Size H/V (picture size horizontal/vertical)
Note: If the CAN-box does not support the vehicle's CAN, the guide-lines cannot be used.
Advertisement
Table of Contents
