Assembly - ICON PRO-FORM 380 CS User Manual

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call 1-800-445-2480. Assembly re-
quires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the
packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walk-
ing belt or the shipping carton. This is a normal condition. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys
adjustable wrench
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached to
one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
Extra hardware may be included.
M5 Star
Washer (7)–2
Extension Leg Nut
(43)–4
M8 x 15mm
Bolt (8)–6
1. Make sure that the power cord is unplugged.
Position the Base (52) and the two Extension
Legs (45) upside-down as shown.
Attach six Base Pads (63) to the Base (52) and
the Extension Legs (45) with six #8 x 1" Tek
Screws (26).
and your own Phillips screwdriver
, scissors
M8 Star
M8.5 Washer
Washer (5)–6
M4 x 10mm
Ground Screw (84)–1
M8 x 58mm Bolt (13)–4
M10 x 75mm Bolt (2)–4
, needlenose pliers
M10 Star
Washer (9)–6
(32)–4
M4.2 x 19mm M5 x 16mm
Screw (10)–6 Screw (85)–2
1
26
63
26
63
26
6
,
, and rubber mallet
M10 Flat Washer
(14)–2
#8 x 1" Tek Screw
(26)–6
M10 x 60mm Bolt (1)–2
26
52
63
45
26
63
63
.
26
63