Toro Multi Pro 5600 Service Manual page 93

Removal (Fig. 55)
1. Park the machine on a level surface, engage the
parking brake, and stop the engine. Remove the key
from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. Disconnect one hydraulic hose from the bottom of
the hydraulic reservoir to drain reservoir (see Operator's
Manual).
4. Disconnect remaining hydraulic hoses from reser-
voir.
5. Remove hydraulic reservoir from machine using Fig-
ure 55 as a guide.
Inspection
1. Clean hydraulic reservoir with solvent.
2. Inspect reservoir for leaks, cracks, or other damage.
Installation (Fig. 55)
1. Install hydraulic reservoir to machine using Figure 55
as a guide.
2. Lubricate new o–rings and reconnect hydraulic
hoses to reservoir (Fig. 56).
3. Fill reservoir with hydraulic fluid as required (see Op-
erator's Manual).
4. Operate machine and inspect for leaks.
Multi Pro 5600
4
1. Hose (from oil cooler)
2. Hose (from piston pump)
Page 4 – 59
3
2
1
Figure 56
3. Hose (to piston pump)
4. Hose (to gear pump)
Hydraulic System