Toro Multi Pro 5600 Service Manual page 147

The agitation switch on the spray console is used to en-
ergize the agitation valve motor and open the valve. The
open valve allows system flow to reach the three agita-
tion nozzles located in the spray tank.
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves, and eye protection during repair.
Disassembly (Fig. 23)
1. Disassemble agitation valve motor as needed using
Figures 23 and 24 as guides. Discard all removed o–
rings and gaskets.
2. See Boom and Agitation Valve Motors in this section
for disassembly and reassembly information of the
agitation valve motor.
Assembly (Fig. 23)
NOTE: Coat all o–rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Reassemble agitation valve motor assembly using
Figures 23 and 24 as guides. Replace all removed o–
rings.
2. Install agitation valve motor assembly on machine
(see Spray Control Assembly in this section).
3. Operate spray system and check for leaks.
Multi Pro 5600
1
2
1. Agitation valve motor
2. Agitation supply hose
3. LH boom valve motor
Page 6 – 25
4
3
5
Figure 24
4. Center boom valve motor
5. RH boom valve motor
Spray System