Toro Multi Pro 5600 Service Manual page 159

Disassembly (Fig. 32)
IMPORTANT: Make sure to remove and neutralize
chemicals from tank and spray components before
disassembly. Wear protective clothing, chemical re-
sistant gloves, and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Drain spray tank (see Operator's Manual).
3. Raise tank lid and remove strainer basket to gain ac-
cess to chain (item 7) that connects drain handle (item
1) to plunger in drain assembly (item 8). Disconnect
chain from drain handle.
4. If necessary, remove drain handle and bulkhead
from tank using Figure 32 as a guide.
5. If necessary, remove drain assembly from tank:
A. Remove fork from drain assembly to allow hose-
barb to be removed from drain assembly.
B. Remove bulkhead nut that secures drain assem-
bly to spray tank.
C. Lift drain assembly from bottom of tank.
6. Disassemble drain assembly using Figure 35 as a
guide.
7. Discard all removed o–rings and gaskets.
Assembly (Fig. 32)
NOTE: Coat all o–rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Assemble drain tube using Figures 32 and 35 as
guides. Replace all removed o–rings and gaskets.
2. Check spray tank for leaks.
Multi Pro 5600
1
3
6
8
10
1. Adapter
2. Plunger holder
3. Spring
4. Drain plunger
5. O–ring
6. Drain seat
7. O–ring
Page 6 – 37
2
4
5
7
9
11
12
13
Figure 35
8. Drain bulkhead
9. Fork
10. Gasket
11. Bulkhead nut
12. O–ring
13. Hosebarb
Spray System