Toro Multi Pro 5600 Service Manual page 163

Disassembly (Fig. 39)
1. Park machine on a level surface, lower booms, stop
engine, engage parking brake, and remove key from the
ignition switch.
2. Support boom to prevent it from falling. Remove cap
screw and hex nut that secure boom support to break-
away assembly.
3. Remove hex nut, flat washer, and carriage screw
that secure support bracket to breakaway pivot. Slide
support bracket from breakaway assembly.
CAUTION
Spring in breakaway pivot is under tension. To
prevent possible personal injury, compress
spring before removing roll pin. Wear eye
protection when removing roll pin.
4. Compress spring in breakaway assembly slightly.
Drive roll pin from hinge (Fig. 41). Remove flat washer
and spring from assembly.
5. Complete disassembly as required using Figures 39
and 40 as guides.
Assembly (Fig. 39)
1. Assemble breakaway pivot using Figures 39 and 40
as guides.
2. Lubricate grease fitting on breakaway pivot after as-
sembly is complete (see Operator's Manual).
Multi Pro 5600
3
4
1. Breakaway pivot
2. Support bracket
1. Roll pin
Page 6 – 41
2
1
Figure 40
3. Boom support
4. Boom extension pipe
1
2
Figure 41
2. Spring
Spray System