Toro Multi Pro 5600 Service Manual page 145

IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves, and eye protection during repair.
Disassembly (Fig. 21)
1. Separate boom valve motors as needed using Fig-
ures 21 and 22 as guides. Discard all removed o–rings
and gaskets.
2. See Boom and Agitation Valve Motors in this section
for disassembly and reassembly information of boom
valve motor.
Assembly (Fig. 21)
NOTE: Coat all o–rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Reassemble boom valve motor assembly using Fig-
ures 21 and 22as guides. Replace all removed o–rings.
2. Before installing rod (Item 22) into assembly, thread
nut (item 16) fully onto rod end that has fewer threads.
Make sure that o–ring (Item 20) is not damaged during
installation over rod.
3. Install boom valve motor assembly on machine (see
Spray Control Assembly in this section).
4. Operate spray system and check for leaks.
Multi Pro 5600
1
7
1. Agitation valve motor
2. LH boom valve motor
3. Center boom valve motor
4. RH boom valve motor
Page 6 – 23
3
2
6
Figure 22
5. RH boom supply hose
6. Center boom supply
7. LH boom supply hose
Spray System
4
5