Atto Fibrebridge Maintenance Service Commands - ATTO Technology FibreBridge 2100R Software Manual

ATTO Technology, Inc.
Configures the data handshaking method used for controlling the flow between the transmitter
and receiver. Serial port flow control may be managed using hardware flow control, software flow
control (Xon/ Xoff) or no flow control. The default setting is no flow control.

ATTO FibreBridge Maintenance Service Commands

FcLIP (Immediate)
Syntax: FcLIP PortNumber
Returns:
(terse)
(verbose)
Issues a LIP on the Fibre Channel interface.
FibreChannelReset (Immediate)
Syntax: FibreChannelReset
Returns:
(terse)
(verbose)
Causes a reset of the Fibre channel port. There is no get version of this command.
FibreBridgeModel
Syntax: get FibreBridgeModel
Returns:
(terse) (FibreBridge XX00)
(verbose)
© 2000 ATTO Technology, Incorporated
Firmware version mm.mm release date dd mmm yyyy Build zzzz
Reports the specific ATTO FibreBridge model information.
FirmwareRestart (Immediate)
Syntax: FirmwareRestart <forced>
Returns: after a pause, POST results and the startup screen wil be deployed
This command will cause the ATTO FibreBridge to reboot and re-initialize its firmware.
PowerStatus
Syntax: get PowerStatus [a | b]
Returns:
(terse)
(verbose)
Displays the status of the specified power supply.
[successful | ERROR: Loop Down]
FcLip [successful | ERROR: Loop Down]
[successful | NOT successful]
FibreChannelReset [successful | NOT successful]
ATTO FibreBridge
[Unavailable | OK]
PowerStatus [a | b] = [Unavailable | OK]
ATTO Technology, Inc.
ATTO FibreBridge Software Manual
13
- -