Attaching The Mower To The Tractor - SaMASZ KDT 220 Operator's Manual

OPERATOR'S MANUAL REAR DISC MOWER

5.1. Attaching the mower to the tractor

WARNING!
Only hitch and unhitch machine on a flat surface with compact dirt.
❑
Keep everyone away from area between mower and tractor.
❑
Be careful near link road zone of tractor's rear power lift. Contains sharp parts.
❑
Any accidental maneuvering with the set may cause to crushing of
❑
unauthorized personnel
Mower's frame is adjusted to be attached to the tractors with 3-point-linkage (Fig. 8).
The mower has been attached, adjust (on the flat ground) the mower's position by means of top S and
lower W links. The cutterbar should lean towards the driving direction.
Secure the adjustable pin with the bolt (R), next counter-screw the mounting with a nut (N) (Fig. 9).
WARNING!
Proper securing of the pins must be inspected regularly before using the mower.
Lower links W should be connected to 3-point linkage frame pins A. Support chain L holds up mower's
linkage frame. Insert and tighten the safety pins into the pin holes and make sure that they are well
locked.
Connect hydraulic hose to tractor's hydraulic connector.
A
KDT
Ł
W A
Fig. 8. Connecting the mower to the tractor
R
N
Fig. 9. Proper pin locking during the mower mounting
S B
21