Adjusting Force Of The Prssure Of Roller Conditioner - SaMASZ KDT 220 Operator's Manual

1. Scarfier shaft
2. Self-locking nut M12 z. Property Class 8.8
3. Washer
4. Plastic flail
5. Bolt M12x55 z. Property Class 8.8
6. Plastic flail insert
Tab. 5. Torque values for bolts
In the absence of specific torque values, the following chart can be used as a guide to the
maximum safe torque for a particular size and grade of fastener. There is no torque difference for fine
or coarse threads. Torque values are based on clean, dry threads. Reduce value by 10% if threads are
oiled before assembly.

6.10. Adjusting force of the prssure of roller conditioner

(Models: KDT 220 W and KDT 260 W)
With factory set rollers, a ridge on one roller should enter a groove on the other. Clearance between a
ridge and a groove on rollers should be within 2-5mm.
If need be, the force of the roller conditioner's pressure can be regulated by changing the tension of
springs S (Fig. 33) by means of the nut N. Adjustment should be done on both sides of the conditioner
38
KDT REAR DISC MOWER
Fig. 32b. Replacement of flails in light-weight conditioner roller
OPERATOR'S MANUAL
1
2
3
4
6
5