Cut To Standard Size - Canon TA-30 Online Manual

Hide thumbs Also See for TA-30:

Table of Contents

Cut to standard size

Specifies standard size as the output page size when printing on roll paper.

This setting item is displayed by tapping in the following order.

(Setup) > Device settings > Print settings > HP-GL/2 print settings > Paper settings

Cuts to standard size in accordance with the roll paper width.

When there are two lengths/widths applicable for a given roll paper width, the optimum size is selected

automatically.

• If ON is selected for Conserve paper and there is blank space above/below the image, the size will

not be standard size.

• When ON is selected for Print centered, printing will be in the center of the standard size.

• If there is no standard size corresponding to the roll paper width, operation is the same as if OFF is

selected. No message is displayed.

• For information about supported standard sizes, see

• OFF (Initial setting)

Cutting according to standard size is not performed.

STANDARD CUT EXAMPLES

• A3-size width roll paper

A. Position of cut when OFF

B. Position of cut when ON

• A3-size width roll paper

Standard Size