Canon TA-30 Online Manual page 64

6. After paper feeding has started, do the following operations based on the Manage
remaining roll amount setting and the barcode printed on the roll paper (see
Track of the Amount of Roll Paper
• When selecting Disable or Warning message only in Manage remaining roll amount.
A menu for selecting the media type appears on the operation panel. Operate the operation panel
and select the media type to be used.
• When selecting Barcodes in Manage remaining roll amount and if the barcode is printed.
The type and amount of paper left is automatically detected based on the barcode printed on the
roll. There is no need to specify the type and length of the paper.
• When selecting Barcodes in Manage remaining roll amount and if the barcode is not
printed.
A menu for selection of the media type and length is shown on the operation panel. Operate the
operation panel, select the media type to be used, and enter its length.
Important
• When selecting Enable in Keep media type, there is no need to specify the type of the paper.
• Cut the edge of the roll using the Cut paper function if the edge is creased or soiled. (See
"Specifying the Cutting Method for
• When selecting the media type on the operation panel, make sure the media type set in the printer
driver and the media type loaded on the printer match.
Note
• For details on media types that you can select, see "Paper Information List."
• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors
or the blade after removing creased edges. (See
• Adjusting the printhead alignment with the type of paper to be used in printing may enhance
printing quality. (See
Left").
Rolls.")
"Automatic Adjustment to Straighten Lines and
64
"Specifying the Cutting Method for
Colors.")
"Keeping
Rolls.")