Lan Settings - Canon TA-30 Online Manual

LAN settings

This setting item is displayed by tapping Device settings after tapping
screen.
Important
• The administrator password is required to change settings if it is enabled for changing settings using
the operation panel.
Note
• You can also enter LAN settings by tapping
• Wi-Fi
The following setting information on the Wi-Fi connection is displayed. (Some items are not displayed
depending on printer settings.)
Items
Connection
Network name (SSID)
Communication mode
Channel
Wi-Fi security
IPv4 address
IPv4 subnet mask
IPv4 default gateway
IPv4 DNS dynamic setting
IPv4 DNS host name
IPv4 DNS domain name
IPv6 link-local address
IPv6 link-local prefix length
IPv6 manual address
IPv6 manual prefix length
IPv6 stateless address 1
(Network) on the HOME screen.
Setting
Enabled (connected) / Enabled (disconnected) / Disa-
ble
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX (up to 32 characters)
Infrastructure
1 - 13
Disable / WEP (64 bit) / WEP (128 bit) / WPA-PSK
(TKIP) / WPA-PSK (AES) / WPA2-PSK (TKIP) / WPA2-
PSK (AES)
XXX. XXX. XXX. XXX (12 characters)
XXX. XXX. XXX. XXX (12 characters)
XXX. XXX. XXX. XXX (12 characters)
Enable / Disable
XXXXXXXXXXXX
XXXXXXXXXXXX
XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX (32 characters)
XXX (up to 3 digits)
XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX (32 characters)
XXX (up to 3 digits)
XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX (32 characters)
150
(Setup) on the HOME