Table of Contents
Advertisement
Over-the-Air Programming (POP 25, ASTRO
25, ASTRO Conventional)
This feature enables configuration data and firmware
to be upgraded to your radio over-the-air. Full use of
the radio is retained during the data transfer without
interrupting communication. For ASTRO 25 and
ASTRO Conventional, the upgrade pauses to give
priorities to voice call, and continues after the voice
call ended. For Wi-Fi
concurrently with voice calls.
Once a configuration upgrade is downloaded to your
radio, you can install new changes immediately or
delay changes to be installed on the radio when it is
being powered up.
Your radio can also be configured to allow you to
accept or reject an upgrade.
Note:
This feature must be preprogrammed by a
qualified radio technician. Check with your
dealer or system administrator for more
information.
®
, the upgrade process runs
Responding to the Notification of Upgrade
1 The display shows Upgrade? and two short,
medium- pitched tones sound every 30 seconds
until the user makes a choice of either accepting,
delaying, or rejecting the request
2 Perform one of the following actions:
Press the Menu Select button below Acpt to
•
accept the request to upgrade immediately.
Press the Menu Select button below Dlay to
•
delay the request to upgrade.
Press the Menu Select button below Rej to
•
reject the request to upgrade.
One of the following scenarios occurs:
•
If you choose to accept, the display shows
Programming Dont power off to indicate the
upgrade is about to begin. The radio resets to
install the upgrade. In the case of configuration
data upgrade, the process only takes a few
seconds. In the case of firmware upgrade, the
installation takes several minutes.
157
English
Advertisement
Table of Contents
