Over-The-Air Programming (Pop 25, Astro 25, And Astro Conventional); Voice Announcement - Motorola APX 7000 User Manual

2.14.13.2.2
Disabling the Sensor Permanently
Procedure:
1 Long-press the preprogrammed Sensor button to permanently disable the sensors.
A tone sounds and the radio displays Sensor Off. While in this state, no events is reported
over-the-air (OTA), regardless of how many times the gun is drawn, re-inserted or weapon is
fired.
The radio generates a bad key tone if the sensor is not allowed to be disabled or there is no
sensor connected to the radio when the preprogrammed button or menu select button is
pressed.
2 Long-press the preprogrammed Sensor button again to enable the OTA Sensor notification.
A tone sounds, and the radio displays SNSR OFF.
2.15
Over-the-Air Programming (POP 25, ASTRO 25, and ASTRO
Conventional)
This feature enables configuration data and firmware to be upgraded to your radio over-the-air. Full
use of the radio is retained during the data transfer without interrupting communication. For ASTRO 25
and ASTRO Conventional, the upgrade pauses to give priorities to voice call, and continues after the
voice call ended. For Wi-Fi, the upgrade process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio, you can install new changes immediately or
delay changes to be installed on the radio when it is being powered up.
NOTICE: This feature must be preprogrammed by a qualified radio technician. Check with your
dealer or system administrator for more information.
2.16

Voice Announcement

This feature enables the radio to audibly indicate the current feature mode, zone, or channel the user
has just been assigned to. This feature is useful when you have difficulty reading the content on the
display.
If preprogrammed by a qualified radio technician, the following occurs:
• Channel Announcement is played in the following scenarios:
- When the radio powers up.
- When you change to a new zone.
- When you change to a new channel.
- When you press a preprogrammed button or switch.
• Feature Voice Announcement is played when you change the state of a feature. Various features
can have Voice Announcement assigned to indicate the on/off state of the features.
The available voice announcement priority options are:
High
Voice announcement is enabled even when the radio is receiving calls.
6875952M01-NK
Advanced Features
75