Disabling Holster Sensor Temporarily; Disabling Holster Sensor Permanently; Over-The-Air Programming (Pop 25, Astro 25, And Astro Conventional And Wi-Fi) - Motorola 3.5 User Manual

Disabling Holster Sensor Temporarily

1 Short-press the preprogrammed Sensor button to
disable OTA Sensor notification.
A tone sounds and the radio displays Sensor
Disable.
2 Press the Menu Select button directly below Sensor
Disable to disable the OTA notification.
The radio remains in this state for a time specified in
radio's codeplug programming. If the timer expires
without an unholster event, a tone sounds, the radio
re- enables the sensor feature and clear sensor
status from the display.
3 When the gun is placed back in the holster, a tone
sounds, the radio enables the OTA sensor
notification and the radio displays Sensor On
temporarily.
4 Long press the preprogrammed Sensor button to
cancel this operation and enable the sensor
notification.

Disabling Holster Sensor Permanently

1 Long-press the preprogrammed Sensor button to
disable OTA Sensor notification.
A tone sounds and the radio displays Sensor Off.
While in this state, no holster events will be reported
OTA, regardless of how many times the gun is
drawn or re-inserted.
2 Long-press the preprogrammed Sensor button
again to enable the OTA Sensor notification.
A tone sounds, and the radio displays Sensor On.
The radio generates a bad key tone if the sensor is
not allowed to be disabled.
Over-the-Air Programming (POP 25,
ASTRO 25, and ASTRO
Conventional and Wi-Fi)
This feature enables configuration data and firmware to be
upgraded to your radio over-the-air. Full use of the radio is
retained during the data transfer without interrupting
communication. For ASTRO 25 and ASTRO Conventional,
English
177