Table of Contents
Advertisement
7.4
Display machine control software version
The query of the software versions only serves to inform the authorised service staff!
0
1
Display
7.5
General operating problems
7.5.1
Interface for mechanised welding
No function of the external shut-down devices (emergency stop switch)!
If the emergency stop circuit has been realised using an external shut-down device via
the interface for mechanised welding, the device must be set for this setup. If this is not
observed, the power source will ignore the external shut-down devices and will not shut
down!
•
Disconnect jumper 1 on PCB T320/1 (Tetrix) or M320/1 (Phoenix / alpha Q)!
099-000098-EW501
03.08.2011
0
1
Setting/selection
Exit the menu
Exit
Service menu
Modifications to the service menu may only be carried out by authorised maintenance
staff!
Software version query (example)
07=
System bus ID
02c0=
Version number
System bus ID and version number are separated by a dot.
Display machine control software version
NOTE
Figure 7-2
WARNING
Rectifying faults
71
Advertisement
Table of Contents
