Table of Contents
Advertisement
2.3
General
Electromagnetic fields!
The power source may cause electrical or electromagnetic fields to be produced which
could affect the correct functioning of electronic equipment such as IT or CNC devices,
telecommunication lines, power cables, signal lines and pacemakers.
•
Observe the maintenance instructions! (see Maintenance and Testing chapter)
•
Unwind welding leads completely!
•
Shield devices or equipment sensitive to radiation accordingly!
•
The correct functioning of pacemakers may be affected (obtain advice from a doctor if
necessary).
Do not carry out any unauthorised repairs or modifications!
To avoid injury and equipment damage, the unit must only be repaired or modified by
specialist, skilled persons!
The warranty becomes null and void in the event of unauthorised interference.
•
Appoint only skilled persons for repair work (trained service personnel)!
Electric shock!
Welding machines use high voltages which can result in potentially fatal electric shocks
and burns on contact. Even low voltages can cause you to get a shock and lead to
accidents.
•
Do not touch any live parts in or on the machine!
•
Connection cables and leads must be free of faults!
•
Switching off alone is not sufficient!
•
Place welding torch and stick electrode holder on an insulated surface!
•
The unit should only be opened by specialist staff after the mains plug has been unplugged!
•
Only wear dry protective clothing!
•
Wait for 4 minutes until the capacitors have discharged!
Risk of injury due to radiation or heat!
Arc radiation results in injury to skin and eyes.
Contact with hot workpieces and sparks results in burns.
•
Use welding shield or welding helmet with the appropriate safety level (depending on the
application)!
•
Wear dry protective clothing (e.g. welding shield, gloves, etc.) according to the relevant
regulations in the country in question!
•
Protect persons not involved in the work against arc beams and the risk of glare using
safety curtains!
Explosion risk!
Apparently harmless substances in closed containers may generate excessive pressure
when heated.
•
Move containers with inflammable or explosive liquids away from the working area!
•
Never heat explosive liquids, dusts or gases by welding or cutting!
099-000098-EW501
03.08.2011
Safety instructions
DANGER
WARNING
General
9
Advertisement
Table of Contents
